WELCOME TO TIGA STEEL GROUP
1.Galvanized steel strip description
Galvanized steel strip is a steel product that is produced from a hot rolled strip that has
been pickled.
The coil is then reduced by a single stand cold roll steel mill straight away
or reversing mill or in a tandem mill consisting of several single stands in a series.
Galvanized steel strip is reduced to approximately final thickness by cold-rolling directly,
or with the inclusion of an annealing operation at some intermediate thickness to facilitate
further cold reduction or to obtain mechanical properties desired in the finished product.
2.Galvanized steel strip flow chart
Decoiler---Shearer---- welder---- pre-treatment---- entry looper---- annealing furnace----
zinc pot ----air cooling tower ----water cooler ----leveller -----post treatment ----exit looper
crimper----Splitting
3.Galvanized steel strip main usage scope:
Galvanized steel strip is mainly used as important building materials in construction:steel
profiles for wall partition,suspension ceiling,cable tray,air duct, etc.
4. Galvanised steel strip advantages:
1)Zinc coating has good adhesion
2)Resistant to corrosive factors
3)High strength&quality
4)Strict quality control system
5)Standard export sea-worthy packing
5. Why choose us?
1.CUS-STEEL advantages:two production line of PPGI
two lines for the galvanised steel coil,
total yearly output is about 500000mt
56 professional salesperson from three international sales department
a group of technical engineers and skillful quality control inspector.
2.Special technology support: manufacture the special products,such as Printed , Filmed ,
Pressed,Matte steel coil
the full hard G550 galvanized steel and galvalume steel.
3.Conform the international quality standard: standard of Europe, Japan, Russia and America to product
Packing details:
Galvanized steel strip stocks:
Standard |
Steel Grades |
Application |
| GB/T 2518-2004 |
01 |
Common commercial application |
| 02 |
For mechanical engagement |
| 03 |
For stamping |
| 04 |
For deep drawing |
| 220,250,280,320,350 |
For structural components |
| JIS G 3302-1998 |
SGCC |
Common application |
| SGCD1 |
For stamping |
| SGCD2 |
For deep drawing |
| DIN EN 10142-2000 |
DX51D+Z |
For common application and mechanical engagement |
| DX52D+Z |
For stamping |
| DX53D+Z |
For deep drawing |
| DIN EN 10147-2000 |
S220GD+Z |
For structural components |
| S250GD+Z |
| S280GD+Z |
| S320GD+Z |
| S350GD+Z |
Audited Supplier 
){kind=link}
){kind=link}